Kenwood KRF-X9050D - Manual (Page 35)

35
Remote Control
The remote control supplied with this receiver is also capable of
controlling components from a variety of manufacturers once
you register the appropriate setup codes into the remote control
unit. Repeat steps 2 to 3 to register additional components
until all components have been registered.
4
Note
Although each setup code is designed to work with a number of different
models, certain codes may not work with some models. (Also, certain
codes may only operate some of the functions available on a given
model.)
This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off
automatically with the receiver via the system control connections.
Operating other components
Use the input selector keys to select the component you
desire.
Note
Be sure to point the remote control at the remote sensor on the receiver
when you want to operate KENWOOD components connected by
system control cords. Otherwise, point the remote control at the compo-
nent you want to operate.
The remote control mode returns to the receiver operation mode
when you do not operate for more than 15 seconds.
1
2
3
Press the operation keys you desire. r
• Pressing the input selector keys also changes the input selector on
the receiver.
• When you operate your registered TV, VCR, DVD player, Cable
tuner, or DSS receiver, go to step
2 .
• When you operate the CD player, Cassette deck, MD player, or
Tuner with system control connection, go to step
3 .
• To return to the receiver operation mode, press the RECEIVER key.
Press the source POWER key.
Input Component Maker Code Key
(DVD) DVD player KENWOOD 5115 DVD
1
Registering setup codes for other components
Find the setup code of the component to be registered.
• Refer to the setup code lists to find the setup code for the component
to be registered. fl
Example: To register a DVD made by KENWOOD, you would enter
“5115”.
2
Hold down the POWER key and press the numeric keys to
enter the setup code.
Low battery warning
Press the source POWER (TV, VCR1, VCR2, DVD) key for
more than 2 seconds, and check to see that the component
you want to control turns on.
• Example: Press “5115” to register a DVD player made by KENWOOD.
• If you push an invalid key, the remote will exit the setup mode.
If the component does not react, and there is more than one
setup code, enter another setup code and try again.
• If the component is already on, pressing the source POWER keys for
more than 2 seconds will turn it off.
3
Basic remote control operations for other components
RC-R0714 RC-R0715
Source
POWER
keys
Source
POWER
keys
POWER
Numeric keys
RC-R0714 RC-R0715
Source
POWER
keys
POWER
Source
POWER
keys
Replace all two batteries with new ones when you notice a shortening
of the distance from which the remote control will operate. The remote
control is designed to retain setup codes in memory while you change
batteries.