KVH Industries TracVision L2 - Manual (Page 20)

2-6
A Guide to TracVision L2
11. Cut the tie-wraps holding the antenna unit to the
forward shipping restraint (see Figure 2-6).
12. Remove the nuts and washers securing the
shipping restraints to the baseplate. The positions
of all three shipping restraints are pictured in
Figure 2-7.
13. For convenient storage, rotate the shipping
restraints 180 º and secure them to their original
mounting bolts using the nuts and washers
removed in Step 12 (see Figures 2-8 through 2-10).
All nuts and washers removed in Step 12 must
be reinstalled. These nuts and washers secure the
baseplate to the mounting plates.
Rotating Plate
Shipping Restraint
Rotating Plate
Shipping Restraint
Forward Shipping
Restraint for
LNB Bracket
Figure 2-7
TracVision L2 Shipping Restraints
(Top View, Installed for Shipping)
Do not discard the shipping
restraints. They should be stowed
for future use in case the antenna
unit needs to be removed and
shipped to another location. Four
1 ⁄
4
˝ x 5 ⁄
8
˝ hex head screws have been
provided in the kitpack for shipping
as the bolts used to hold the
shipping restraints during initial
shipping are integral parts of the
mounting plates.
Forward Shipping Restraint
Installation Bolts and Washers
LNB
Figure 2-8
Forward Shipping
Restraint Storage
2 tie-wraps used
to secure LNB arm
Shipping Restraint
Shipping Restraint
Nuts and Washers
Figure 2-6
Forward Shipping Restraint
(Arranged for Shipping)