Kenwood HM-233 - Manual (Page 15)

15
Basic Operation
- Setting the Cloc
k -
Setting the Clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
Note:
The time will flash at the push of the CLOCK button when the AC power supply is
restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the Clock" from the beginning.
To change the 24-hour or 12-hour display:
1
Press the CLOCK button and within 3 seconds, press the MEMO-
RY button.
2
Within 1 minute, press the PRESET ( or ) button to select 24-
hour or 12-hour display and then press the MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
Note that this can only be set when the unit is first installed or it has been reset.
(Refer to step 3 under "If trouble occurs" on page 26.)
3
Within 1 minute, press the PRESET ( or ) button to adjust the
hour and then press the MEMORY button.
When the 12-hour display is selected, "AM" will change automatically to "PM".
4
Within 1 minute, press the PRESET ( or ) button to adjust the
minutes and then press the MEMORY button.
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.)
To confirm the time display when the power is on:
Press the CLOCK button.
The time display will appear for about 5 seconds.
1 Clear all the programmed contents. [Perform to step 3 under "If trouble occurs" on
page 26 for details.]
2 Perform "Setting the Clock" from the beginning.