Kenwood HM-233 - Manual (Page 23)

23
Ad
v
anced Features
-
Timer and Sleep Operation -
To reset or change the timer setting:
Perform "Timer playback" from the beginning.
Notes:
Once the time is set, the setting will be retained until a new time is entered.
When performing timer playback using another unit connected to the VIDEO/AUX
IN sockets, select "VIDEO/AUX" in step 2. At this time, only this unit will be turned
on or enter the power stand-by mode automatically. It will enter the power stand-by
mode 1 hour after the timer playback starts. (Another unit will not be turned on or
off.)
Sleep operation
To cancel the sleep operation:
Press the ON/STANDBY button whilst the sleep timer is set.
To confirm the remaining sleep time:
Press the SLEEP button once whilst the sleep timer is set.
The remaining sleep time is displayed for about 3 seconds.
To use timer and sleep operation together
Example: To fall asleep and wake to the same radio station
You can play back the same source only (the function cannot be switched).
6
Within 1 minute, press the PRESET ( or ) button to specify the
minutes to start, then press the MEMORY button.
The timer playback starting time, function, and volume will be displayed, and
then the unit will enter the stand-by mode automatically.
" " will appear and the current time will be displayed.
To cancel the timer playback:
Press the ON/STANDBY button to turn the power on.
7
When the preset time is reached, playback will start.
The volume will increase gradually until it reaches the volume you were listening
at before your system enters the timer stand-by mode.
8
If you select CD, the unit will enter the stand-by mode after the
playback. If you select TUNER, it will enter the stand-by mode one
hour after the timer playback starts.
1
Play back the desired sound source.
2
Press the SLEEP button.
To change the sleep time:
Press the SLEEP button repeatedly to select the desired sleep time. The time
will decrease as follows.
The amount of sleep time can also be changed whilst in the sleep mode.
3
Your system will enter the power stand-by mode automatically af-
ter the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
1
Set the sleep time (see above, steps 1 - 2).
2
Whilst the sleep timer is set, set the desired playback time (steps
4 - 6, pages 22 - 23).
3:00 2:00
OFF 15 30
1:30 1:00