Kenwood HM-233 - Manual (Page 20)

20
Radio
- Listening to the Radio -
Listening to the Radio
To receive an FM stereo transmission:
Press the FUNCTION (BAND) button to display the "ST" indicator.
" " will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the FUNCTION (BAND) button to extinguish the
"ST" indicator. The reception changes to monaural, and the sound becomes
clearer.
After use:
Press the ON/STANDBY button to enter the power stand-by mode.
1
Press the ON/STANDBY button to turn the power on.
2
Press the FUNCTION button until "FM" or "AM" appears on the dis-
play.
When operating with the remote control, press the TUNER button, and then the
BAND button to select "FM" or "AM".
3
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
This can be operated by pressing the TUNE ( or ) button on the remote
control.
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING button again.
FM stereo mode indicator
FM stereo receiving indicator