Krell Industries KCT User Manual
Page 2
KCT
Krell Current Tunnel
CAST Preamplifier
v 01.0
Krell Industries, Inc.
45 Connair Road
Orange, CT 06477-3650 USA
TEL 203-799-9954
FAX 203-891-2028
E-MAIL [email protected]
WEBSITE http://www.krellonline.com
This product is manufactured in the United States of America. Krell ® is a registered trademark of Krell Industries, Inc., and is restricted for use by Krell
Industries, Inc., its subsidiaries, and authorized agents. Sustained Plateau Bias III™ is a trademark of Krell Industries, Inc. and is a Krell technology based
on U.S. Patent No. 5,331,291. CAST™, CAST II™, Krell Current Mode™, Krell Link™, and Theater Throughput™ are trademarks of Krell Industries, Inc.
All other trademarks and tradenames are registered to their respective companies.
© 2000 by Krell Industries, Inc. All rights reserved
P/N 304373
This product complies with the EMC directive (89/336/EEC) and the low-voltage directive (73/23/EEC).
WARNINGS
The preamplifier must be placed on a firm, level surface where it is not exposed to dripping or splashing.
The ventilation grids on the top of the preamplifier and the space underneath the preamplifier must be
unobstructed at all times during operation. Do not place flammable material above or beneath the preampli-
fier.
Before making connections to the preamplifier, ensure that the power is off and other components are in mute
or stand-by mode. Make sure all cable terminations are of the highest quality, free from frayed ends, short cir-
cuits, or cold solder joints.
Do not connect an RS-232 cable to the phono power port. Output from the phono power port could seriously
damage your computer. Do not connect the cable from a Krell KPE phono stage to the RS-232 port.
THERE ARE NO USER SERVICEABLE PARTS INSIDE THE PREAMPLIFIER
Please contact your authorized Krell dealer, distributor, or Krell if you have any questions not addressed in
this manual.