Krell Industries KCT User Manual
Page 33
Krell Current Tunnel
29
8. Repeat steps 4 through 6.
9. Press the menu button (15) or key (41) to exit the menu mode.
BRIGHTNESS
This option allows you to adjust the front panel display brightness.
1. Press the menu button (15) or key (41) to access the main menu.
2. Use the level control knob (14) or level keys (44) to select
BRIGHTNESS
.
3. Press the enter button (16) or key (42). The front panel display (13) shows
HIGH
(the
default).
4. Use the level control knob (14) or level keys (44) to select the desired brightness
option (
HIGH
,
FULL
,
BRIGHTNESS OFF
,
LOW
,
AND MEDIUM
). The front panel display (13)
illustrates each level of brightness.
5. Press the enter button (16) or key (42) to return to the main menu or press the menu
button (15) or key (41) to exit the menu mode.
Note
If you choose
OFF
, the front panel display will remain on until you exit the menu mode.
Press menu again to display the main menu.
MUTE MENU
This option allows you to customize mute button or mute key to operate in either the
main zone or zone 2, only in the zone that is currently active, or in both zones.
1. Press the menu button (15) or key (41).
2. Use the level control knob (14) or level keys (44) to select
MUTE MENU
.
3. Press the enter button (16) or key (42). The front panel display (13) shows
MUTE
ACTIVE
ZONE
(the default).
4. Use the level control knob (14) or level keys (44) to highlight the mute options (
MUTE
ZONE
1,
MUTE ZONE
2,
MUTE BOTH ZONES
,
MUTE ACTIVE ZONE
).
5. Press the enter button (16) or key (42) to return to the main menu or press the menu
button (15) or key (41) to exit the menu mode.
OUTPUT TRIGGER SETUP
This option allows you to configure the activation of three 12 VDC (12 Volt trigger)
outputs to be always off or on, or to activate only with selected zones.
1. Press the menu button (15) or key (41) to access the main menu.
2. Use the level control knob (14) or level keys (44) to select
OUTPUT TRIGGER SETUP
.
3. Press the enter button (16) or key (42). The front panel display (13) shows
TRIGGER
1.