KORG SP 250 - Manual (Page 41)

Assembling the stand 39
11 Place the piano in the location where it will be played. Please be sure to place it over
a flat floor, to avoid any shaking.
Note: Be careful not to pinch the power cable under the piano feet.
12 Tighten and check all the screws.
Check after assembly
[•] Are any parts left over?
If any parts are left over, check the diagrams to see where they should be used.
[•] Make sure that all screws are tight.
Caution
Caution when transporting the instrument. Remove the piano from its stand, and
transport them separately. After transportation, refer to these instructions and re-
assemble the piano and stand.
Screw loosening. After assembly, the various screws and bolts of the stand may
loosen as time goes by, causing the stand to wobble. If this occurs, re-tighten the
screws.
Disassembly. If you need to packup the piano, reverse the assembly order by which
the piano was attached to the stand and the stand was assembled. After disassembly,
save the screws and other parts so that no parts are lost.