Knoll Systems Front Projector 1080p DLP - Manual (Page 58)

57
Appendix
Removing and Installing the Lamp Unit
Follow these instructions to replace the lamp.
• Be sure to remove the lamp unit by the handle. Be sure not to touch the glass surface of the lamp unit or
the inside of the projector.
• To avoid injuring yourself and damage to the lamp, be sure to carefully follow the steps below.
• Do not loosen other screws except for the lamp unit cover and lamp unit.
(Only the silver screws are loosened).
1. If the projector is running, press on the projector or on the remote control to
turn off the power. Wait until the cooling fan stops.
Warning!
Do not remove the lamp unit from the projector right after use. The lamp will be very hot and may cause burn
or injury.
2. Disconnect the power cord and wait at least an hour for the lamp to cool.
3. Remove the lamp unit cover.
• Loosen the user service screw that secures the lamp unit cover. Then open the cover in the direction of the
arrow.
INPUT 1
INPUT 2
STATUS
EXIT
INPUT
MENU
ECO
ENTER
M4* 8.9 screws