Kenwood DNX7360BTM User Manual
Page 63
DDX series DDX8036BT/ DDX8036BTM/ DDX7036BT/ DDX7036BTM English
63
Next page
3
Next page
3
4
Set the Graphic Equalizer
DDX8 series
1
1
1
DNX7/ DDX7 series
1
1
1
1 Gain level can be adjusted by
touching the each frequency bar.
[
2], [3] Sets a frequency.
[
5], [∞] Sets a gain level.
[EQ Init] Returns to the previous level
which the gain level is adjusted.
[Flat] Tone curve becomes flat.
[Bass EXT] Bass Extend settings.
When turned on, the frequency lower
than 62.5 Hz is set to the same gain
level as 62.5Hz.
[SW Level] Adjusts the subwoofer
volume.
The setting is available when subwoofer
is set to any item other than "None". See
<Speaker Setup> (page 83).
Zone Control
Zone Control
You can set the front and rear audio
source.
1
Display the Zone Control screen
Touch [
]
>
>
[
]
>
>
[Zone
Control]. (page 61)
2
Set the Zone Control
[Single Zone] Sets the unit to single
zone.
[Dual Zone] Sets the unit to dual zone.
[Front Source] Sets the front audio
source.
[Rear Source] Sets the rear audio
source.
⁄
• When the rear speaker sound is switched,
the audio source that is output at the AV
OUTPUT terminal is also switched to the
same source.
[Rear VOL.] Adjusts the volume of the
rear channel.