Lathem TRUALIGN TIME RECORDER 800P - Manual (Page 28)

800P TruAlign Time Recorder User Guide
Page 29
Appendix A - Changing the Print Intensity
How to change the print intensity on the timecard
If the imprint on the timecard is getting faint you may wish to
increase the print intensity setting from the factory setting of
5. See the instructions below.
Enter the ‘Setup Mode’. See Page 13.
Press the SET button until you get to Function 13
Use the
+
button to scroll through and set the desired
print intensity level.
Press the SET button through Function 14 and 15.
The time recorder will go to the normal time/date display
with the changes to the print intensity applied.
Example: Set the print intensity from 5 to 7
Step 1
Press the or
-
button until the display
shows ‘7’.
Step 2
Press the SET button when the setting is
correct. The setting will be accepted,
continue pressing the SET button through
Function 14 and 15.
The time recorder will go to the normal
time/date display with the changes to the
print intensity applied.
Note: If you scroll past the setting you wish,
continue pressing the or
-
button until
the desired setting displays, then press the
SET button.
13: 7
13: 5
Print Intensity
Function #