Lathem TRUALIGN TIME RECORDER 800P - Manual (Page 32)

800P TruAlign Time Recorder User Guide
Page 33
Appendix C - Testing the Print Head
When should I run the test on the print head?
If you notice that the imprint on the timecard appears to be
missing segments, you can test the print head to make sure it is
working correctly.
To test the print head, see the instructions below.
Enter the ‘Setup Mode’. See Page 13.
Press the SET button until you get to Function 15
Example: Set the print test to 4 imprints
Step 1
Press the or
-
button until the display
shows ‘4’. Note: Any value between 2 and 9
puts the time recorder into print head test
mode.
Step 2
Press the SET button when the setting is
correct. The time recorder will be in the
print head test mode.
Note: If you scroll past the setting you wish,
continue pressing the or
-
button until
the desired setting displays, then press the
SET button.
15: 4
15: 0
Step 3
With the time recorder in a normal
time/date display. Insert a timecard and
make an imprint. The imprint should look
similar to the example.
Make 3 additional imprints, after the 4 th
imprint the time recorder will have
completed the ‘print head test mode’ and be
ready to imprint on the timecards normally.
Function #
Print Head
Test