Lenovo TS130 - Manual (Page 58)

6. Insert the two tabs 2 of the new front fan assembly into the corresponding holes in the chassis, and
press the other two tabs 1 through the holes until the front fan assembly is secured in place.
Figure 35. Installing the front fan assembly
7. Connect the new front fan assembly cable to the power fan connector on the system board. See
“Locating parts on the system board” on page 14.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the replacement, go to “Completing the parts replacement” on page 54.
Replacing the rear fan assembly
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 19.
This section provides instructions on how to replace the rear fan assembly.
To replace the rear fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 21.
3. Locate the rear fan assembly. See “Internal components” on page 15.
46 ThinkServer TS130 Hardware Maintenance Manual