Lathem 7500E - Manual (Page 21)

22
17 18
You have completed this setting. Go to the next setting listing in
"Default Settings" on page 5 to continue with the setup.
Job Cost Mode
4
Push the SET button once again.
Example: Change to Job Cost Mode and Card "Reset" is YES.
2
Push the CHANGE button to set the
left-side number at "5" and then push
the SET button. At that moment, the
display will change to the right-side
Default set to 'No'.
number.
SET FUNCTION CHANGE
MODE
Job cost
mode
SET FUNCTION CHANGE
MODE
Set the "Mode".
3
In this case, push the CHANGE
button to set at "2" and then push
the SET button.
Card "Reset"
No
Yes
1
2
Set the card "Reset".
Card "Reset"
is YES
This mode is basically the same as Payroll Mode, but has no pay period. After punching 64
times, the end sign appears.
If you want to be able to reset the card manually without removing the cover, you must select
"Reset is YES". See page 36 on "Resetting Cards In Job Cost Mode".
1
SET FUNCTION CHANGE
MODE
Push the FUNCTION button for 5
seconds and make sure the " " is
positioned under the "MODE" mark.