Resetting cards in job cost mode – Lathem 7500E User Manual
Page 39
Advertising
22
35
36
Resetting Cards In Job Cost Mode
You can reset the card without removing the cover when the time recorder is used under
the following condition.
The Job Cost Mode and also the card "Reset" setting is YES.
Refer to "Job Cost Mode" in "Setting the Mode".
In order to reset the card, you must push the right-side button (Reset button) and then insert
the card.
After printing "RESET", the card shall be ejected.
Once you push the button, the unit starts beeping. Make sure to insert the card while it beeps.
Reset
button
Note: If the last punch was IN, you must insert the card twice.
A fully used card can also be reset by this operation, but without printing the word
"RESET".
Advertising