Lennox Hearth Gas Stove - Manual (Page 9)

9
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installation
i
nstalling
d
oor
t
rim
a
nd
s
pring
h
andle
CAUTION: Always ensure that plated surfaces are clean
and free of fingerprints before lighting stove. Fingerprints
will leave permanent blemishes if left on plated surface
when lit. When installation is complete, the trim should
be gently cleaned with a soft cloth and either alcohol or
glass cleaner. Do not overtighten nuts, overtightening can
create visible dimples on the plated surface.
To install the trim on the door, first see Opening and Remov-
ing Door on page 22. Slide the threaded studs on the trim
through the holes in the door. Install the nuts on the studs
to secure the trim to the door. Do not over tighten the nuts
or they will snap the studs off. To install the spring handle,
first close the door and screw the handle into the receiving
nut. Then spray Windex or water on the shaft of the handle
to act as a lubricant. Next, twist the spring handle counter-
clockwise onto the shaft. Use Windex or alcohol to remove
any fingerprints prior to firing the stove.