Life Fitness CT9500 User Manual
Page 6
Position the Monocolumn assembly (#9) above
the CHANNEL FRAME bracket (A) located at the
top of the Cross-Trainer unit. With the tray facing the ped-
als, slide the MONOCOLUMN assembly down over the
CHANNEL FRAME bracket. With three BOLTS (#3),
attach the MONOCOLUMN assembly to the CHANNEL
FRAME bracket. Tighten the BOLTS securely.
Remove the four HANDRAIL MOUNTING
BOLTS (#15) with WASHERS (#16) FROM THE
HANDRAIL MOUNTING BRACKET (D). Slide the user-
right HANDRAIL (#11) over the HANDRAIL MOUNTING
POST (B) as shown until the HANDRAIL MOUNTING
PLATE (C) is aligned with the HANDRAIL MOUNTING
BRACKET (D) located on the back face of the unit body.
With two BOLTS (#15) with WASHERS (#16), attach the
user-right HANDRAIL MOUNTING PLATE to the
HANDRAIL MOUNTING BRACKET. Tighten the BOLTS
until snug. With two BOLTS (#4) and two nuts (#6), attach
the user-right HANDRAIL (#11) to the HANDRAIL
MOUNTING POST (B). Tighten all four BOLTS securely.
Repeat this step to install the user left HANDRAIL (#12).
Locate the 6-PIN CONNECTOR (6-P) leading
from the MONOCOLUMN assembly (#9) and con-
nect it to the 6-PIN CONNECTOR (6-P) on the back of the
DISPLAY CONSOLE (#10).
Locate the 5-PIN CONNECTOR (5-P) for the
telemetry/stop switch module leading from the MONO-
COLUMN assembly (#9) and connect it to the 5-PIN
CONNECTOR (5-P) on the back of the DISPLAY CON-
SOLE (#10).
Locate the 4-PIN CONNECTOR (4-P) for the Heart Rate
sensors leading from the MONOCOLUMN assembly (#9)
and connect it to the 4-PIN CONNECTOR (4-P) on the
wire harness extending from the back of the DISPLAY
CONSOLE (#10).
Place the DISPLAY CONSOLE (#10) on the Display
Console Bracket (E), insert the four DISPLAY CONSOLE
SCREWS (#1) and tighten in a criss-cross manner
.
NOTE: Be sure to feed all cables leading from the
channel frame bracket up and through the monocol-
umn assembly before mounting the monocolumn
assembly to the channel frame bracket.
1
1
Be careful not to pitch any of the cables
between the monocolumn assembly and the
channel frame bracket.
3
3
2
2