Life Fitness 8205 - Manual (Page 16)

16
STEP 16
FIGURE 16
• Attach one 5/16” SNAP HOOK (24) and one STRAP (15) to the ball
end of the CABLE (18). See FIGURE 16.
1 8
• Screw the threaded end of CABLE (18) approximately 3/4” into the
SWIVEL HOLDER (5) and tighten jam nut SECURELY as shown
in FIGURE 16.
2 4
1 5
5
• Repeat STEPS 6-16 to assemble cable on other
side of the CABLE CROSS OVER.
• If the HEAD PLATE (17) does not sit on top of the first WEIGHT
PLATE (41), push the head plate down, insert the SELECTOR PIN
(21) and perform several repetitions on the machine. This will relax
the cable system and prevent the HEAD PLATE (17) from lifting up.
• If after completing the previous step the HEAD PLATE (17) still
does not sit on top of the first WEIGHT PLATE (41) or if there is
excess slack in the cable system, adjust the threaded end of the
CABLE (18) accordingly and RETIGHTEN the jam nut.
4 1
1 7
• SECURELY assemble one 1/2 X 3/4” BUTTON HEAD CAP
SCREW (12) to the SWIVEL HOLDER (5). See FIGURE 16.
1 2
4 0
2 1
3 9
• Apply one set of WEIGHT STACK LABELS - LBS. OR 1-25 (39)
(40) to each WEIGHT PLATE (41) as shown in FIGURE 16.
• Insert the WEIGHT STACK PIN (21) into the first WEIGHT PLATE
(41) of the WEIGHT STACK as shown in FIGURE 16.