Lennox Hearth WHITFIELD 30 FS-2 User Manual
Page 31
31
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE
Cat. No. H0369
Model Profi le 30 INS-2
Pellet Insert
Flue Size
3” (75 mm) Rear
Width, Overall front (w/o surround)
26” (660 mm)
Width, Overall back (w/o surround)
24-1/8” (613 mm)
Depth, Overall (w/o surround)
26-1/4” (667 mm)
Height, rear (w/o surround)
19-15/16” (506 mm)
Height, front (w/o surround)
23-5/8” (600 mm)
Floor to Rear
Flue Center
9-1/4” (235 mm)
Fireplace Face to Rear
Flue Outlet Center (3” tee)
13-1/4” (337 mm)
Dimensions into Fireplace
Minimum Height
20-1/8” (511 mm)
Minimum Width @ Front
(extends back 1 ½”)
32” (813 mm)
Minimum Width @ Back
24-5/8” (626 mm)
Minimum Depth
17-3/4” (451 mm)
Facing Back of Unit,
Right Outside Edge of Unit
to Center of Rear Flue Outlet
5” (127 mm)
Floor to Rear
Outside Air Inlet
2-1/8” (54 mm)
Facing Back of Unit,
Right Outside Edge of Unit
to Center of Air Inlet
12-7/16” (316 mm)
Floor Protection
Requirements
Front: 6” (152 mm)
Standard Features
Fastfi re™ Self Igniter
Wall
Thermostat
(wire
included)
Hopper Capacity
50 lbs.
Burn time
11 - 30 hours
Fuse, Control Board
5 Amp, 250 volt, 3AG
Fuse, Igniter
6 Amp, 125 volt
Heat Input (Max.)
14,000 - 38,000 BTU / hr
Overall Effi ciency
81%
Emissions
1.9 gr / hr (varies w/size and
type of fuel) EPA exempt
Ship Weight
230 lbs.
Room Air Blower
150 CFM; .8 Amps, 2175 rpm
Exhaust Blower
95 CFM: 1.0 Amps, 3000 rpm
Auger Motor
1.1 RPM; .4 Amps
Options
Nickel or Gold Trim Kits
4” Quick Disconnect
Log
Set
BACK VIEW
SIDE VIEW
32”
24-1/8”
5”
2-1/8”
12-1/2”
Combustion
Air Inlet
Damper
Arm
Control
Board
9-1/4”
26-1/4”
13”
23-5/8”
19-7/8”
Clean-Out
Tee
2-3/4”
Damper
Arm
Control
Panel
17-3/4”
5”
31-3/4”
25-3/4”
TOP VIEW
Note: Dimensions shown are approximations only (+/- 1/4”)
Non-combustible fl oor protection must be used when installed on carpet
(see Hearth Protection, Page 7).
Fuel delivery and burn times will vary depending on size and type of fuel
used. Estimated heat input based on fuel value of 8400 BTU per lb.
Fuses are rated as fast blow
SPECIFICATIONS - PROFILE
®
30 INS-2