Life Fitness 95Ti - Manual (Page 41)

40
U
SING
T
HE
M
AX
T
IME TM S
ETUP
This feature allows the club to set different maximum workout durations to accomodate various
traffic flows throughout the day. The real-time clock must be correct to fully utilize this feature.
Refer to Section 1.2 Setting the Clock.
After entering the Manager’s Configuration, select the MAXTIME
TM SETUP option. The MES-
SAGE CENTER displays the statement “MAXTIME CONTROL OFF” and then displays a maxi-
mum workout duration value. The default value is 60 minutes, and it can be changed with the
INCLINE or SPEED ARROW keys. This value is always in effect unless the MAXTIME
TM control
feature is turned on.
To turn the feature on, use the INCLINE or SPEED ARROW keys, and switch the setting to
MAXTIME CONTROL ON. Then, press ENTER.
The MESSAGE CENTER displays a “peak duration” value, which is the maximum possible
workout duration, in minutes, during high-traffic hour for fitness clubs. Use the ARROW keys or
the NUMERIC keypad to increase or decrease the displayed value, and press ENTER. The
MESSAGE CENTER then displays a “non-peak duration” value, which is the maximum possible
workout duration all other times. Use the ARROW keys or the NUMERIC keypad to increase or
decrease the displayed value, and press ENTER.
The MESSAGE CENTER then displays a “peak 1” time period in hours and minutes. This is the
period during which the peak workout duration value is in force. Use the TIME ARROW keys to
change the hours, and use the INCLINE ARROW keys to change the minutes. Press ENTER.
The MESSAGE CENTER then displays the “peak 1” duration value, which is the amount of time
in minutes that the peak period remains in force. Using the ARROW keys, change the value,
and press ENTER.
The MESSAGE CENTER then displays a “peak 2” time period. Repeat the steps described in
the preceding paragraph to set up a second peak time.
U
SING
T
HE
S
TANDBY
S
ETUP
This feature will automatically turn the treadmill power off and on at designated times, typically
at the opening and closing of a facility. The real-time clock must be correct to fully utilize this
feature. Refer to Section 1.2 Setting the Clock.
Select the STANDBY SETUP option. The MESSAGE CENTER displays the statement, “STAND-
BY DISABLED”. Using the ARROW keys, switch the setting to ENABLED. The MESSAGE CEN-
TER displays an “auto off” value, which is the time of day, in hours and minutes, at which the
treadmill automatically switches off. Use the TIME ARROW key to change the hours, and use
the INCLINE ARROW key to change the minutes. Press ENTER. The MESSAGE CENTER dis-
plays an “auto on” value, which is the time of day, in hours and minutes, at which the treadmill
automatically switches on.