Lowrance electronic Lowrance iFINDER Hunt - Manual (Page 66)

58
3. If the list is short, you can jump directly to the F IND I N L IST
box by
pressing ENT . Use
↑ or ↓ to select the waypoint name, press
ENT and the
waypoint information screen appears with the G
O
T
O
command selected.
4. To begin navigating to the waypoint, press ENT .
Navigate a Trail
1. Press
MENU | MENU |
↓ to
M
Y
T
RAILS
| ENT and a screen similar to the
one below appears.
Trails Menu, Advanced Mode.
2. Use
↓ to ↑ to select a trail to navigate.
3. With the trail name highlighted, press ENT |
↓ to
N AVIGATE
| ENT .
4. Wait while iFINDER creates a route from the trail. When the prog-
ress message disappears, the unit displays a trail information screen,
with the
N
AVIGATE
R
OUTE
command highlighted in the top command box.
Tip: Back Track a Trail
Running the Navigate command will lead you along the trail from its
starting point to its ending point. You can also back track a trail, or
follow it in reverse order (from its ending point to its starting point.)
In Easy Mode, this is done automatically with the most recently cre-
ated active trail. In Advanced Mode, you must first select the Reverse
command to reverse the trail point order before you start navigating:
press
→ to
R EVERSE R OUTE
| ENT |
← to
N AVIGATE
.
5. To follow the trail, press ENT . The unit begins showing navigation
data along the trail. Follow the steering arrow on the Map Page or the
compass bearing arrow on the Navigation Page.
NOTE:
If you are at or near the start of the trail, the arrival alarm will go
off as soon as navigation begins because of your proximity to the
trail's first point. Just press
EXIT to clear the alarm.