Life Fitness Peak Pilates Reformer - Manual (Page 23)

20 Unpacking and Assembling the Peak PilateSystem
Assembling the Arm Springs (Deluxe Model only)
To assemble the Arm Springs (444 mm (17.5 in) long):
1. Using the Double Ended Clips, attach Arm Spring to
each side of the Roll Down Bar.
2. Store the Arm Springs by hooking them to the upper
eye bolts located in the back of the Tower.
Assembling the Push Through Bar Spring (Deluxe
Model only)
To assemble the Push Through Bar Spring:
1. The Push Through Bar Spring is covered with a vinyl
sleeve. It is stored stretched between the two eye
bolts that are located at the bottom of the Tower.
Assembling the Safety Chain (Deluxe Model only)
To assemble the Safety Chain:
1. Using the Safety Link, attach one end of the chain to
the outside eyebolt on one side of the Riser Cap.
2. Attach the other end to the ring on the Push Through
Bar.
Warning: Tighten the Safety Link locks.The Safety Chain is to remain attached to the Riser
Cap and the Push Through Bar at all times. Do not remove the Safety Chain under any
circumstances.
Roll Down Bar
Arm Spring
Riser Cap