LevelOne NetCon WBR-3408 - Manual (Page 62)

Advanced Features
Data - Special Applications Screen
Name Enter a descriptive name to identify this Special Application.
Incoming
Ports
• Type - Select the protocol (TCP or UDP) used when you receive
data from the special application or service. (Note: Some applica-
tions use different protocols for outgoing and incoming data).
• Start - Enter the beginning of the range of port numbers used by
the application server, for data you receive. If the application
uses a single port number, enter it in both the "Start" and "Finish"
fields.
• Finish - Enter the end of the range of port numbers used by the
application server, for data you receive.
Outgoing
Ports
• Type - Select the protocol (TCP or UDP) used when you send
data to the remote system or service.
• Start - Enter the beginning of the range of port numbers used by
the application server, for data you send to it. If the application
uses a single port number, enter it in both the "Start" and "Finish"
fields.
• Finish - Enter the end of the range of port numbers used by the
application server, for data you send to it. If the application uses
a single port number, enter it in both the "Start" and "Finish"
fields.
Using a Special Application
• Configure
the Special Applications screen as required.
• On your PC, use the application normally. Remember that only one (1) PC can
use each Special application at any time. Also, when 1 PC is finished using a par-
ticular Special Application, there may need to be a "Time-out" before another PC
can use the same Special Application. The "Time-out" period may be up to 3 min-
utes.
If an application still cannot function correctly,
try using the "DMZ" feature.
Multi-DMZ
This feature, if enabled, allows the DMZ computer or computers on your LAN to be
exposed to all users on the Internet.
• This allows almost any application to be used on the "DMZ PC".
• The "DMZ PC" will receive all "Unknown" connections and data.
• If the DMZ feature is enabled, you must select the PC to be used as the "DMZ
PC".
To use this feature:
• Enter an IP address allocated to you by your ISP into the WAN IP address field.
• Select
the PC to be the DMZ PC for traffic sent to this IP address.
59