LevelOne GSW-2600TXM - Manual (Page 140)

140
Parameter Default Description
Area ID¹ A 32-bit integer uniquely identifying an OSPF protocol
broadcast area. This identifier can be in the form of an IP
address or integer. Each port on the switch can be configured
to represent one OSPF area.
ID 0.0.0.0 is used for the OSPF backbone.
Router Priority 1 The priority used when selecting the designated router and
designated backup router.
Range: 0-255; Disable election: 0
Transit Delay 1 second The estimated number of seconds it takes to transmit a link
state update packet over this interface.
Range: 0-3600 seconds
Retransmit
Interval 5
seconds The number of seconds between retransmitting link-state
advertisements to router adjacencies on this interface. This
value is also used when retransmitting database descriptions
and link-state request packets.
Range: 0-3600 seconds
Hello
Interval² 10
seconds The interval, in seconds, between sending Hello packets out
the router interface.
Range: 1-65535 seconds
Dead
Interval² 40
seconds The number of seconds that a router’s Hello packets have not
been seen before its neighbors declare the router down. This
should be a multiple of the Hello interval.
Range: 1-65535 seconds
1. The Area ID is used to specify a group of contiguous networks and hosts. OSPF
protocol broadcast messages are restricted by area to limit their impact on network
performance.
2. This value must be the same for all routers attached to a common network.