LevelOne GSW-2600TXM - Manual (Page 23)

23
Baud Rate 19200 The rate at which data is sent between devices.
Options : 9600, 19200 and 38400 baud.
Data Bits 8 bits Sets the data bits of the RS-232 port.
Options : 7, 8
Stop Bits 1 bit Sets the stop bits of the RS-232 port.
Options : 1, 2
Parity None Sets the parity of the RS-232 port.
Options : none, odd, even
Timeout 0 minutes If no input is received from the attached device after this
interval, the current session is automatically closed.
Range : 0 - 100 minutes; where 0 indicates disabled
Auto Refresh 10 second Sets the interval before a console session will auto-refresh the
console information, such as Spanning Tree Information, Port
Configuration, Port Statistics, and RMON Statistics.
Range : 0-255 seconds; where 0 indicates disabled
2.4.3.Assigning SNMP Parameters
Use the SNMP Configuration screen to display and modify parameters for the Simple
Network Management Protocol (SNMP). The switch includes an onboard SNMP agent
which monitors the status of its hardware, as well as the traffic passing through its ports.
A computer attached to the network, called a Network Management Station (NMS), can
be used to access this information. Access rights to the onboard agent are controlled by
community strings. To communicate with the switch, the NMS must first submit a valid
community string for authentication. The options for configuring community strings and
related trap functions are described in the following sections.
SNMP Configuration
==================
Send Authentication Fail Traps : ENABLED
SNMP Communities ...
IP Trap Manager ...
<OK>
Send a trap or not when SNMP authentication fails. |
READ/SELECT
Use <TAB> or arrow keys to move, <Space> to scroll options.
Parameter Description
Send Authentication
Fail Traps
Issue a trap message to specified IP trap managers whenever
authentication of an SNMP request fails. (The default is enabled.)
SNMP Communities Assigns SNMP access based on specified strings.