Lenovo THINKSERVER 392 - Manual (Page 138)

3. The non-hot-swap hard disk drive(s) are installed in the lower hard disk drive cage and are protected
by an EMI-protective panel. Press the small tab 1 on the EMI-protective panel from the bottom and
then pivot the EMI-protective panel upward to remove it from the chassis and gain access to the
non-hot-swap hard disk drive(s).
CPU
MEM
PSU
CPU
MEM
PSU
1 2
Figure 63. Removing the EMI-protective panel
4. Remove the server cover. See “Removing the server cover” on page 85.
5. Remove the front system fan 1. See “Replacing the front system fan” on page 149.
6. Locate the appropriate non-hot-swap hard disk drive. See “Server components” on page 25. Then,
disconnect the SATA signal cable and the power cable from the rear of the non-hot-swap hard disk drive.
126 ThinkServer Hardware Maintenance Manual