Lenovo THINKSERVER 392 User Manual
Page 43
The following illustration shows the components of the server with up to four 3.5-inch non-hot-swap hard
disk drives.
Figure 14. Components of the server with up to four 3.5-inch non-hot-swap hard disk drives
1
DIT module (available in some models)
9
Front system fan 1
2
Front panel
10
System board battery
3
Optical drive bay 2 (with an optical drive installed
in some models)
11
Expansion card (varies by model)
4
Optical drive bay 1 (with an optical drive installed)
12
Heat sink and fan assembly
5
Hard disk drive bay 3
13
System board
6
Hard disk drive bay 2
14
Rear system fan
7
Hard disk drive bay 1
15
Power supply
8
Hard disk drive bay 0
16
Four memory slots (installed memory modules vary by
model)
• For more information about
1
to
4
, see “Front view of the server” on page 15.
Note: The DIT module
1
is only available in some models and the DIT panel also varies by model.
• Each of the hard disk drive bay (
5
to
8
) is used for installing a 3.5-inch non-hot-swap hard disk drives.
Note: The number of the installed hard disk drives varies by model.
• For information about the supported expansion card, see “System board components” on page 42.
Chapter 3
.
Product overview
31