52 flash full, 53 unformatted flash detected, 54 network <x> software error – Lexmark 280 User Manual
Page 152: 54 serial option <x> error, 54 standard network software error, 55 unsupported option in slot <x, 56 parallel port <x> disabled
52 Flash full
•
Press the down arrow button until Continue appears, and then press to clear the message and continue
printing.
Downloaded fonts and macros not previously stored in flash memory are deleted.
•
Delete fonts, macros, and other data stored in flash memory.
•
Upgrade to a larger capacity flash memory card.
53 Unformatted flash detected
•
Press the down arrow button until Continue appears, and then press to stop the defragment operation
and continue printing.
•
Format the flash memory. If the error message remains, the flash memory may be defective and require replacing.
54 Network <x> software error
•
Press the down arrow button until Continue appears, and then press to continue printing.
•
Turn the printer power off and then back on to reset the printer.
•
Upgrade (flash) the network firmware in the printer or print server.
54 Serial option <x> error
•
Check that the serial cable is connected correctly and is the proper one for the serial port.
•
Check that the serial interface parameters (protocol, baud, parity, and data bits) are set correctly on the printer
and host computer.
•
Press the down arrow button until Continue appears, and then press to continue printing.
•
Turn the printer power off and then back on to reset the printer.
54 Standard network software error
•
Press the down arrow button until Continue appears, and then press to continue printing.
•
Turn the printer power off and then back on to reset the printer.
•
Upgrade (flash) the network firmware in the printer or print server.
55 Unsupported option in slot <x>
1
Turn the printer power off.
2
Unplug the power cord from the wall outlet.
3
Remove the unsupported optional interface card or internal print server from the printer system board.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer power back on.
56 Parallel port <x> disabled
•
Press the down arrow button until Continue appears, and then press to clear the message.
The printer discards any data received through the parallel port.
•
Make sure the Parallel Buffer menu item is not set to Disabled.
Understanding printer messages
152