Linksys E1000 - Manual (Page 7)

Linksys E1000 Chapter 2: Cisco Connect
4 Wireless-N Router
b . Plug the power adapter into an electrical outlet .
Connect to Electrical Outlet
c . Unplug the existing Ethernet cable from your
computer and plug it into the yellow port labeled
Internet on the back of the Router . Click Next .
Internet Ethernet 4 3 2 1 Reset Power 12VDC
Connect Ethernet Cable
NOTE: You can view detailed connection steps
by clicking in the setup software .
NOTE: If the setup software detects multiple
routers, then select the serial number of your
Router . The serial number is located on the
left side of the product label, which is on the
bottom of the Router .
5 . Please wait while the setup software is setting up the
Router .
Please Wait
6 . The installation is complete . Click OK .
Installation is Complete
NOTE: If you have any problems during the
installation process, refer to the Frequently
Asked Questions in the setup software, or use a
computer with an active Internet connection to
visit www.linksys.com/support .
Main Menu
When Cisco Connect starts up, the main menu appears:
Main Menu
Status information is displayed in the upper right corner:
• online secure
Your local network is secure, and your Internet
connection is available .
• offline secure
Your local network is secure; however, your Internet
connection is not available . To repair your Internet
connection, follow the on-screen instructions .
NOTE: A group of computers or other devices
connected to a router is a local network .
The router allows the networked devices to
communicate with each other .