Philips DTR1000 - Manual (Page 33)

10.1 Restore virgin mode
"Install wizard" is shown only once at the
first power up of your receiver.
If you want to reinitialise your receiver and
put it back to virgin / factory mode, follow
the steps below.
• Disconnect your receiver from the mains.
• Keep pressing the Front Panel '+' button
while re-connecting your receiver to the
mains.
• The left hand LED will start to blink orange
while right hand LED is off.
• Release the Front Panel '+' button.
• Briefly press the front Panel '+' button.
• Right hand LED turns on RED and the left
hand LED is blinking Red.
• Enter the following code with the remote
control: '9' '9' '0' '0'.
• Once entered, the left hand LED turns
shortly Green. In case of a bad code
entered, the left hand LED stays Red.
• Wait until the receiver re-starts by
displaying the First Install Wizard.
Note: After this procedure, your PIN code has
also been reset to its factory setting ('0', '0', '0',
'0'), and all "Favourite" lists will be lost.
10.2 Change remote control
setting
If you have other equipment in your home
and the remote control of the Philips
receiver interferes with them, you can
change the setting of the remote control.
Change Remote Control Configuration:
- Press number buttons 1 and 3
simultaneously for 3 seconds.
- Release the two buttons simultaneously.
- Enter the new setting within 60 seconds:
- By pressing number button 4
(corresponding to new setting).
- Or by pressing number button 3 to
come back on the default factory
setting.
Note: At first power up of the remote control (or
battery change while pressing a button) the
default factory setting (value 3) is restored.
Change Receiver Remote Control
Configuration:
- After you changed the remote control
setting to the desired value:
- Disconnect your receiver from the
mains.
- Keep on pressing the Front Panel '+'
button while re-connecting your
receiver to the mains
- up to the time the Multicoloured
LED is blinking orange while Red LED
remains on all the time.
- Then release the '+' button.
- Press the OK key on your remote
control.
- The Multicoloured LED becomes
Green if the new code is accepted.
- The Multicoloured LED becomes Red
if the received code is not accepted.
The receiver will then use the default
factory setting of the remote control.
10.3 You forgot your PIN code /
Master PIN code
If you have forgotten your PIN code, you
have the possibility to reset it to the default
PIN Code ('0', '0', '0', '0').
To reset the PIN Code, you have to enter
the Master PIN Code in any Pin Code
request menu. This will have the effect to
accept the PIN Code and to reset the PIN
Code to the default PIN Code of the
receiver.
The Master PIN Code is the following:
('RED', '3', '8', '9', '5').
Note: Keep this code secret to prevent your
children from using it.
ADVANCED SETTINGS 31
10 Advanced settings
English