Wr-201e, Connections, Connectable pa systems – Panasonic WU-RM205E User Manual

Page 21: Cable diameters binding cables

Advertising
background image

CONCEPT

SYSTEM

EXAMPLES

CONNECTIONS

PR

ODUCTS

BLOCK

D

IA

GRAMS

41

3

CONNECTIONS

WR-201E

CONCEPT

SYSTEM

EXAMPLES

CONNECTIONS

PR
ODUCTS

BLOCK

D

IA

GRAMS

40

3

CONNECTIONS

WR-201E

CONNECTIONS

PA System Name

Number of Possible Connections

Name

Type

Remote Microphone (WR-201E)

Mixing Power Amplifier

WA-MA120N

2

WA-MA240N

2

Connectable PA Systems

Refer to the following table to determine the number of Remote Microphones that can be connected to the PA systems.

Cable Diameters

Binding Cables

Bind the cables as shown in the figure below.

The insulation at the end of a cable being
connected should be stripped to 11 mm
(standard strip length).

11 mm

Cable Lengths

200 m or less

500 m or less

Shielded cable

0.5 mm

2

(AWG20) to 1.25 mm

2

(AWG16)

Control cable

ø

0.8 mm (AWG20) to

ø

1.2 mm (AWG16)

ø

1.2 mm (AWG16)

PA System Name

Cable Type

Mixing Power Amplifier

Shielded pair cable

• Use cables that have a line resistance of 7 Ω or less if one

of the cables listed above is not available.

• Use a multicore cable if you intend to move the Remote

Microphone freely around on the table while using it.

Use an adequate shielded cable (either a one wire or two-wire type according to the
PA system being used) for connecting to the LINE OUT terminal.

Mixing Power Amplifier (WA-MA120N/240N) Connection-1

Select -22 dBV (RM) with the switch 1 on the back of the Mixing Power Amplifier.
Volume should be adjusted to the desired level using the Volume control [RM] knob 2 on the back of Mixing Power Amplifier
(WA-MA120N/240N).

Making connections for all-zone announcements

Note 1

Note 1:

Connect to play the Mixing Power Amplifier's call sign from the CALL SIGN button on the Remote Microphone.

Note 2:

When using more than one Mixing Power Amplifiers, refer to the instructions on Connection between Mixing Power

Amplifiers. (See page 43.)

Important:

• Set the call sign volume-control on the bottom of the Remote Microphone to its lowest setting to use the Mixing Power Amplifier's

built-in call sign.

WA-MA120N

or

WA-MA240N

WR-201E

Advertising