Wu-zm001e, Recording methods, Products – Panasonic WU-RM205E User Manual
Page 29: Major operating controls & terminals, Connecting external equipment, Recording formats
CONCEPT
SYSTEM
EXAMPLES
CONNECTIONS
PR
ODUCTS
BLOCK
D
IA
GRAMS
57
4
PRODUCTS
WU-ZM001E
CONCEPT
SYSTEM
EXAMPLES
CONNECTIONS
PR
ODUCTS
BLOCK
D
IA
GRAMS
56
4
PRODUCTS
WU-ZM001E
MAJOR OPERATING CONTROLS & TERMINALS
Front View
Rear View
RECORDING METHODS
Notes on recording
• Sound data is recorded to the SD memory card. Do not remove the SD memory card during recording.
• You can switch the time display between elapsed recorded time and remaining recording time by pressing the SCHEDULE
switch while recording.
Connecting external equipment
External equipment is connected as shown below.
• Connecting to REC IN
Connect the external equipment's audio signal out or microphone to this jack. Set the audio signal level (LINE/MIC) to match the
device that you are connecting.
• Connecting to PHONES
Connect headphones to this jack.
Note:
REC IN terminal of this unit is for unbalanced
input. The audio message could not be recorded
if the input is balanced. Please use microphones
or equipment of unbalanced output.
SELECT
SD CARD
2
1
SCHEDULE
CLK ADJ.
EMG
MESSAGE
REC IN
OUTPUT
PHONES
CANCEL
1
3
RESET
ENTER
MENU
WU-ZM001
2
Microphone,etc.
Headphone
Item
File format
Linear PCM (WAV)
Description
Audio sample rate
44.1 kHz
Audio sample size
16 Bit
Stereo/Mono
Mono
Recording formats
The following sound data formats can be recorded to this Sound Message Unit.
Elapsed recorded time
Remaining recording time
• The recorded sound data file is saved to the "ZM001" folder on the SD memory card.
* Folders are generated automatically when the SD memory card is formatted.
SD memory card
PRIVATE
MEIGROUP
PSS
ZM001
Press the SCHEDULE switch
Press the SCHEDULE switch
Note:
The elapsed/remaining time displayed during recording is not exact. There might be some difference between the displayed time and the actual one.