ProForm PFBE1816.0 - Manual (Page 10)

10
12. Slide a Safety Spotter (11) onto the Right
Upright (5). Insert an Upright Pin (31) through
the Safety Spotter and the Right Upright. Next,
attach the Tether (58) on the Upright Pin to the
Safety Spotter with an M4 x 16mm Screw (47).
Slide a Weight Rest (12) onto the Right Upright
(5). Insert an Upright Pin (31) through the
Weight Rest and the Right Upright. Next, attach
the Tether (58) on the Upright Pin to the Weight
Rest with an M4 x 16mm Screw (47).
Repeat this step for the other side of the
weight bench. Make sure that the Safety
Spotters (11) and the Weight Rests (12) are
at the same height.
13. Attach the Curl Pad (18) to the Curl Post (10) with
two M6 x 25mm Screws (50).
12
14. Make sure that all parts are properly tightened before you use the weight bench. The use of the remaining
parts will be explained in ADJUSTMENTS, beginning on the next page.
13
31
58
47
18
10
50
11
31
58
47
5
12