ProForm PFBE1816.0 - Manual (Page 8)

8
7. Orient the Seat (14) with the wide end in the
position shown. Attach the Seat to the Seat
Frame (6) with four M6 x 75mm Screws (48)
and four M6 Washers (21).
14
21
21
48
48
6
6
5. Orient the Backrest (16) with the wide end in the
position shown. Attach the Backrest to the
Backrest Frame (7) with four M6 x 25mm
Screws (50).
6. Tighten the Backrest Knob (38) into the Seat
Frame (6). Then, pull the Backrest Knob out as
far as it will go. Insert the Backrest Frame (7)
into the Seat Frame and engage the Backrest
Knob into one of the holes in the Seat Frame.
Apply a small amount of the included grease to
an M10 x 85mm Button Screw (57). Attach the
Backrest Frame (7) to the Seat Frame (6) with
the Button Screw and an M10 Nylon Locknut
(49).
Do not overtighten the Nylon Locknut;
the Backrest Frame must pivot freely.
5
16
50 7
50
38
57
Grease
49
7
6
Wide
End
Wide
End
7