ProForm PFBE1816.0 - Manual (Page 7)

7
2. Attach the Left and Right Seat Frame Caps (42,
44) to the Seat Frame (6) with four M4 x 16mm
Screws (47).
Attach the Seat Frame Bumper (29) to the Seat
Frame (6) with an M4 x 16mm Screw (47).
Next, attach the Bumper (34) to the Seat Frame
with an M4 x 16mm Screw (47).
2
4
56
52
49
56
1
28
47
4. Attach the Left Upright (4) to the Left Base (1)
with three M10 x 98mm Button Bolts (56), an
M10 Washer (52), and two M10 Nylon Locknuts
(49).
Attach the Left Foot (28) to the Left Upright (4)
with two M4 x 16mm Screws (47).
Repeat this step for the other side of the
weight bench.
3. Attach the Seat Frame (6) to the Left and Right
Bases (1, 2) with eight M10 x 55mm Button
Bolts (53), eight M10 Washers (52), and eight
M10 Nylon Locknuts (49).
Tighten the Nylon Locknuts (49) used in
step 1 and this step.
See the inset drawing. Attach the Front Foot
(15) to the Left and Right Bases (1, 2) with four
M4 x 16mm Screws (47).
29
34
47
47
47
47
42
44
3
4
6
6
49
53
52
52
2
1
52
52
53
49
49
2
1
15
47
47