ProForm PFBE1816.0 User Manual
Page 9
9
8.
Apply grease to the barrel of the M10 x 70mm
Bolt Set (54) and to the indicated locations on
the Leg Developer (8).
Attach the Leg Developer (8) to the Seat Frame
(6) with the M10 x 70mm Bolt Set (54).
Make
sure the barrel of the Bolt Set is inserted
through both sides of the bracket on the
Seat Frame. Do not overtighten the Bolt Set;
the Leg Developer must pivot freely.
8
9
54
Grease
Grease
Grease
Bracket
8
6
54
9.
Insert a Pad Tube (19) into the Leg Developer
(8). Slide a Foam Pad (20) onto each end of
the Pad Tube. Then, press a Pad Cap (46) into
each Foam Pad.
Repeat this step with the other two Pad
Tubes (19).
10. Attach the Curl Bumper (24) to the Curl Frame
(9) with an M4 x 16mm Screw (47). Next, attach
the Curl Tube (23) to the Curl Frame (9) with an
M10 x 75mm Button Screw (55).
10
46
9
24
55
13
13
47
20
20
46
6
19
8
19
23
11.
See the inset drawing and identify the Curl
Pin (25). Attach the Curl Frame (9) to the Leg
Developer (8) with the Curl Pin. Next, attach the
Tether (58) to the Leg Developer with an M4 x
16mm Screw (47).
9
8
47 58
25
11
25
31