Polaris Trail RMK - Manual (Page 104)

101
MAINTENANCE
Steering System
n
Ski Skags
Check skags weekly to maintain positive steering characteristics. Skags
must be replaced when worn to half their original diameter.
NOTE: Carbide skags must be replaced if any abnormal wear or chip-
ping is found.
Skag Replacement
1. Raise and support the front of
the machine so the skis are
approximately 6 inches (15.2
cm) from the ground.
2. Remove the attaching nuts and
pry the skag downward.
3. Remove the forward portion of
the skag.
Reverse this procedure for new skag installation.
WARNING
Worn skis and/or skags will adversely affect handling. Loss of vehicle control
may result, causing serious injury or death.
See your dealer’s studding chart for recommended skags. If you install
longer or more aggressive carbide skags than the original equipment, it may
also be necessary to add track studs to maintain proper vehicle control while
turning on hard-packed snow or ice.