Polaris Trail RMK - Manual (Page 95)

92
MAINTENANCE
Clutch System
n
Drive Belt Deflection
Measure belt deflection with
both clutches at rest and in
their full neutral position.
Place a straight edge on the
belt (1) and apply downward
pressure while measuring at
point 2. This measurement
should be 1 1/4 inches (32
mm).
Drive Belt Adjustment
TEAM Clutch
1. Loosen the 7/16-inch jam nut on the belt width adjuster.
2. Using a 1/8-inch Allen wrench, adjust the threaded set screw as
needed.
NOTE: Turn the set screw in (clockwise) to increase the distance
between the sheaves and out (counterclockwise) to decrease
the distance.
3. Tighten the jam nut.
Clutch Center Distance
Refer to the specifications section beginning on page 110 for recom-
mended center distance for your machine. If adjustment is necessary,
see your dealer. Due to tolerances in belt length, it may be necessary for
your dealer to make minor adjustments in the driven clutch to achieve
correct belt tension.
1
2