Polaris Trail RMK - Manual (Page 77)

74
MAINTENANCE
Lubrication
Jackshaft Bearing Greasing
Loosen the driven clutch retaining bolt
and pull the clutch outward to expose
the bearing and grease fitting. Inject
grease into the grease fitting in the
flangette until grease purges from inside
or outside the bearing seal (may take
only two pumps). Push the clutch back
onto the shaft and replace the clutch
retaining bolt. Torque to 18 ft. lbs. (24.4
Nm).
Driveshaft Bearing Greasing
Inject grease into the fitting on the speedome-
ter drive adaptor until grease purges from
inside or outside the bearing seal (approxi-
mately two pumps).
Throttle Cable
Lubricate the throttle cable lightly
with grease or oil. With the engine
off, turn the handlebars to the left
and lubricate liberally as shown.
Choke and Cable
Lubricate the choke slide and cables
lightly with oil or grease. Before
turning the engine off, operate the
choke intermittently to draw mois-
ture out of the choke plunger area
and reduce the possibility of the
choke becoming frozen.
+
+
+
+
+