Polaris Trail RMK - Manual (Page 39)

36
THE PERFECT FIT
Handlebar Adjustments
Standard Handlebar
Follow these steps to adjust
handlebar angle at the handle-
bar block.
1. Remove the handlebar
cover to expose the handle-
bar and the four adjuster
block bolts.
2. Using a 7/16-inch wrench,
loosen the four nuts on the
bottom of the adjuster
block (turn the handlebar
either left or right for
access to the rear nuts).
NOTE: If necessary, pry the
blocks apart with a
screwdriver.
3. Adjust the handlebar to the
desired angle. Be sure the
handlebar, brake lever and throttle lever operate smoothly and do
not hit the gas tank, windshield or any other part of the machine
when the handlebar is turned fully to the left or right.
4. Torque the front bolts first, then torque the rear bolts. Torque the
bolts to 11-13 ft. lbs. (15-18 Nm).
5. Reinstall the handlebar cover.
Cover
Nuts
Bolts