Panasonic AW-E300 - Manual (Page 37)

-35-
Neither SHARPNESS nor SUPER HARD is valid for
contour correction if Detail Level setting
!8 is in the
OFF position.
Note
!8 Detail Level Setting [Level: OFF/LOW/HIGH]
Detail level can be adjusted when Detail Select set-
ting
!7 is at Sharpness. Super Hard level can be
adjusted when it is at Super Hard.
In case of using the RCU (RCB), the above can be
adjusted with the contour correction switch (DTL).
IRIS
MAN
AUTO
1000 S/S
ELC
500 120
OFF
SHUTTER SCENE
2 1
3
USER
SET
OFF
ON +18
+9
0(dB) +6
OFF
− 6(dB)
GAIN
BAR
CAM
HIGH
LOW
OFF
RCB
DTL AGC
R B
R B PED
TOTAL
PED
A
B
ATW
AWC
AUTO
HOLD
ABC
AUTO/ATW
PAINTING
GAIN
RCU (RCB)
DTL
!5 Sub Carrier Phase Coarse Adjustment
[SC Coarse: 1/2/3/4]
Coarse adjustment of subcarrier phase can be
made when a genlock signal is supplied.
!6 Subcarrier Phase Fine Adjustment [SC Fine:
–511 - +511]
Fine adjustment of subcarrier phase can be made
when a genlock signal is supplied.
!7 Detail Select Setting [DTL Select: Sharpness/
Super Hard]
If contour correction is not sufficient at the
Sharpness position when Detail Level setting
!8 is
set to LOW or HIGH, select the Super Hard posi-
tion.
!9 Noise Suppress Level Setting [Noise Suppress:
OFF/LOW/HIGH]
Screen noise can be reduced when Detail Level
setting
!8 is at HIGH or LOW.
@0 Clean DNR Setting [Clean DNR: OFF/LOW/HIGH]
Clean DNR effect can be selected.
@1 Detail Flesh Tone Level Setting [Detail Flesh
Tone: LOW/MID/HIGH]
LOW:
Skin color coarseness is suppressed.
MID: Standard
HIGH: Skin color is emphasized.