Panasonic AW-E300 - Manual (Page 42)

-40-
#1 Electronic Shutter Mode Setting [Shutter Mode:
Step/ELC/Synchro Scan]
Step:
Electronic shutter operates at the speed
selected by the Electronic Shutter Step Setting
#2.
ELC: Electronic shutter is controlled to automatical-
ly adjust the luminance.
Synchro Scan: Electronic shutter operates at the
speed selected in Electronic Shutter Synchro-
Scan Setting
#3.
#2 Electronic Shutter Step Setting
[Step: OFF/1/100 - 1/10 000]
This setting is possible only when Step is selected
in Electronic Shutter Mode Setting
#1.
OFF: Electronic shutter is turned off.
1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000,
1/10 000:
Electronic shutter operates at one of these
speeds as selected. Flickering by fluorescent
lights will be reduced at 1/100 in areas where
the power frequency is 50 Hz.
• In case of using the RCU (RCB), none of the
shutter speeds–1/250, 1/2 000, 1/4 000, and
1/10 000 can be selected.
• In case of using the hybrid control panel, only
OFF, 1/100, or ELC can be selected.
• If the lens iris switch is at M (Manual) when oper-
ating the camera alone or when the iris switch on
the RCU (RCB) is at AUTO, ELC may not func-
tion. Set the lens iris switch to A (Auto).
• Flickering may increase at ELC under fluores-
cent lights.
Notes
#3 Electronic Shutter Synchro-Scan Setting [Syncro
Scan: 60.34 Hz - 15.75 kHz]
This setting is possible only when Electronic Shutter
Mode Setting
#1 is at Synchro Scan.
Bar noise can be reduced by synchro-scan adjust-
ment in shooting workstation scenes, for example.
* For luminance setting at each shutter speed and
sychro-scan shutter speed, refer to the table on the
next page.