Pioneer VSX-AX5i-G - Manual (Page 80)

Using Other Functions
80
En
Multi Operations
Multi operations allow you to tell the receiver and your other components to do a number of things with the push of
only two buttons on the remote control. For example, you can program the unit to turn on your TV, turn on your DVD
player and start playing the loaded DVD. This allows you to freely decide which operations you want performed as
well as the order in which you want them performed. The steps below show you how to program a string of up to 5
different operations for each MULTI CONTROL button. You don't need to program power commands for this receiver
or any other Pioneer components. They will automatically turn on when a multi operation is performed.
(Programming Pioneer video components automatically turns on Pioneer TVs.)
Memo:
Be sure to set up each component before programming multi operations (see “Setting Up the Remote
Control to Control Other Components” on page 67).
1 Press the REMOTE SETUP button for
more than three seconds.
The REMOTE SETUP menu appears on the remote display.
2 Use the  buttons to select MULTI
OPE and press ENTER.
SELECT FUNCTION flashes in the remote display.
3 Press the MULTI CONTROL button for
the component you want to start the
multi operations with. MULTI OPE
appears in the display.
For example, DVD/LD
4 Use the  buttons to select first
command. "1st Cmmnd" appears in
the display. Press ENTER.
This tells the receiver this will be the first command.
To erase a command
Select CLEAR and press ENTER. Then go to step 8.
To go back one step
Select EXIT and press ENTER.
5 To setup a command select CHANGE
and press ENTER.
FUNCTION flashes in the display.
6 Select the component whose
command you want to input (for
example, a DVD player), and press
the MULTI CONTROL button for it.
KEY will flash in the display.
7 Select a button for the command you
want to input (for example,  [play]).
COMPLETE appears in the display.
8 Repeat steps 4-7 to program a
sequence of up to five commands.
You can assign multi operations for up to 5 commands for
each MULTI CONTROL button.
Buttons that
can be
programmed
with Multi
Operations
Memo:
• To exit from the REMOTE SETUP mode at
anytime press the REMOTE SETUP button.
• The display will disappear after one minute or
so if no new commands are entered. Press
any button to wake up the remote and
continue the process.
VSX-AX5i.book Page 80 Friday, May 23, 2003 6:33 PM