Pride Mobility Jazzy 1122 - Manual (Page 30)

30 WWW.PRIDEMOBILITY.COM JAZZY 1122/REV D/FEB 03
V I I . D I S A S S E M B L Y
SEAT REMOVAL
You may wish to remove the seat for transportation. If you have
a Versa Seat, please refer to the Versa Seat Installation and Ad-
justment guide.
To remove the seat:
1. Turn the power off.
2. Make sure your Jazzy is not in freewheel mode.
3. Unplug the main wire harness behind the seat.
4. Simultaneously depress the two plungers on the front of the
seat frame while lifting the front of the seat. See figure 31.
5. Lift the seat up and gently lower it back onto the front seat towers.
6. Pull the seat forward and lift it off of the rear seat towers.
To remove a power seat:
1. Release the seat by moving the seat release lever rearward.
2. Lift up the power seat plate.
3. Lift the seat off of the actuator.
FOOT FRAME REMOVAL
The foot frame helps protect the Jazzy components from the envi-
ronment. See figure 32. You must remove the foot frame in order
to change the batteries and check the cable connections.
To remove the foot frame:
1. Turn the power off.
2. Make sure your Jazzy is not in freewheel mode. See IV.
“The Jazzy 1122.”
3. Locate the 5/16-in. pin at the base of the footplate bracket
and remove.
4. Lift the foot frame straight up approximately 2 inches and
pull toward you.
Figure 31. Removing the Seat
Figure 32. Removing the Foot Frame