Pride Mobility Jazzy 1122 - Manual (Page 37)

JAZZY 1122/REV D/FEB 03 WWW.PRIDEMOBILITY.COM 37
V I I I . O P E R A T I O N
CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board
charger/programming socket.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module at the
back of the power base. See figure 34.
Power Module
Typically, the power module is mounted to the power base. The power module provides a power interface for the
joystick module. It routes the battery power to the motors and other powered accessories such as lights and
power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a control and
power interface between the power module, the lights, and/or the power seat actuator.
Sleep Mode
Your Remote Plus controller has a sleep mode feature. Sleep mode is a built-in circuit that automatically shuts off
the main power if the joystick is not moved in any direction for approximately five minutes. The battery condition
meter lights on the keypad indicate sleep mode by blinking once every five seconds. To restore power and con-
tinue, push the on/off key twice.
Thermal Rollback
The Remote Plus is equipped with a thermal rollback circuit. This circuit monitors the temperature of the motors,
power module, and remote. In the event that any of them become excessively hot (above 122° F), motor voltage
is reduced. For every degree above 122° F, the voltage is reduced by 5 volts. This reduces your power chair’s
speed and allows the electrical components to cool down. When the temperature returns to a safe level, your
power chair resumes its normal speed.