Paxar 9445 - Manual (Page 16)

17. Turn the printer on. If you are:
•
replacing the supply with a new roll of the same size,
press
f to align the printer.
•
changing supply size, adjust the supply sensor. See
"Adjusting the Supply Sensor" later in this chapter.
NOTE: Before you print, be sure the menu supply type
setting matches your supply type (e.g. Black
Mark/Die Cut). See your Operator’s Handbook to
set supply options.
Peel Mode
This mode is only used with labels. The printer separates the
label from the backing paper. This mode must be used with On
Demand printing.
1. Open the front panel.
2. Turn the printhead lever to the left to release the printhead.
Printhead
Lever
9445 Equipment Manual
2-8