Paxar 9445 - Manual (Page 32)

7. Guide the new ribbon around the rollers on the ribbon roll
adapter. Slide the upper spool onto the upper spool shaft.
8. Slide the ribbon spool holders against the spools.
9. Turn the upper ribbon spool clockwise to add slight
tension to the ribbon. Make sure the ribbon is tight but
not wrinkled or bunched.
10. Slide the ribbon roll adapter in against the back wall of the
printer
NOTE: To help slide the ribbon roll adapter in or out, it
may be necessary to increase or relax tension on
the ribbon by turning the spools.
Ribbon
Leader
Feed Mark
Rollers Ribbon Roll
9445 Equipment Manual
3-4