Panasonic WV-NP1004 - Manual (Page 15)

15
[Connection example]
When connecting with a PC directly
<Required cable>
LAN cable (category 5, cross)
When connecting via a network
<Required hardware>
Switching hub or router
<Required cable>
LAN cable (category 5, straight)
Important:
• Use a switching hub or a router which is compliant with 10BASE-T/100BASE-TX.
• Power supply is required for each network camera.
• When connecting multiple network cameras, it is necessary to configure the settings of the router in use. It is also neces-
sary to configure port numbers for each network camera independently. Refer to page 21 for further information about the
settings.
Refer to the operating instructions of the router for descriptions of how to configure the router.
LAN cable (category 5, cross)
PC
1
2
3
4
5
ACT
VIDEO OUT
10BASE-T/
100BASE-TX
LINK
POWER
SD CARD
GND
AC24V
IN
1-L
2-N
1
2
3
4
5 GND
DAY/NIGHT IN
AUX OUT
ALARM OUT
ALARM IN
Note: When connecting to the
video input connector of a
device that has the power
switch for the connected
camera, such as the
Panasonic WV-CM142,
turn the power switch for
the connected camera off.
Connect to the video input connector of a frame
switcher, matrix switcher, etc.
Connect to the video input connector of a digital
disk recorder, time lapse VCR, etc.
PC (Refer to page 7 for the
system requirements for a PC)
Video monitor
System device
Recording device
LAN/Internet
Network device
(Hub, router, ADSL/CATV
modem, etc.)
1
2
3
4
5
ACT
VIDEO OUT
10BASE-T/
100BASE-TX
LINK
POWER
SD CARD
GND
AC24V
IN
1-L
2-N
1
2
3
4
5 GND
DAY/NIGHT IN
AUX OUT
ALARM OUT
ALARM IN