Panasonic WV-NP1004 - Manual (Page 18)

18
Configure the Settings Using the Operation Buttons on the Camera
Each setup item on the [Camera] tab of the "Camera setup" page can be configured using the operation buttons on the cam-
era. The settings relating to image quality, brightness, privacy zone and flange-back length can be configured on the
[Camera] tab of the "Camera setup" page. When using the operation buttons, configure the settings while displaying the
"Camera" tab page on the video monitor.
The following are descriptions about the setup items on the [Camera] tab and of how to configure them using the operation
buttons on the camera.
Refer to the network operating instructions (PDF) for further information about the [Camera] tab.
Settings items of the camera setup page
Settings item Description
CAMERA Configure the settings relating to camera operations
CAMERA ID The camera title can be edited and displayed on the screen.
ALC/ELC Select the light control method from "ALC", "ALC+" and "ELC" according to the lens in
use.
SHUTTER Select the shutter speed.
AGC Select the method of the gain adjustment.
SENS UP Adjust the sensitivity.
SYNC Display the method of the synchronization.
WHITE BAL Select the method of the white balance adjustment.
DNR Configure the settings for the DNR (Digital Noise Reduction) function.
BW MODE Configure the settings relating to the BW mode such as the settings for switching
between the color mode and the BW mode.
PRIVACY ZONE It is possible to mask a designated zone and as a privacy zone.
EL-ZOOM Adjust the electronic zoom.
STABILIZER Select "ON" or "OFF" to determine whether or not to use the image stabilizer to prevent
shaky images.
BACK-FOCUS Select the method of the flange-back length adjustment and adjust the flange-back
length minutely.
SPECIAL
CHROMA GAIN Adjust the chroma level (color density).
AP GAIN Adjust the aperture level.
PEDESTAL Adjust the pedestal level (brightness).
HUE Adjust the chroma phase.
PIX OFF Correct image defects such as scratches.
CAMERA RESET SETUP Reset the settings edited on the [Camera] tab to the default settings.
NETWORK Configure the network settings.