POLAR S725 - Manual (Page 11)

A 9
Installing the Polar Bike Mount™
Use cable ties to secure the bike mount
snugly on the rubber pad. Attach the wrist
unit by securing the wrist strap.
Installing the Polar Speed Sensor™
The Polar Speed Sensor measures speed and
distance when cycling.
1. Check the front side of the front fork to
find a suitable place for the speed sensor.
The sensor should be attached less than
50 cm/ 1’8" from the mounted wrist unit.
The smaller the distance the better. Clean
and dry the area underneath the rubber
pad before you attach it to the front fork.
2. Place the sensor in the position as in
illustration 2. Then adjust the sensor
towards the wheel as much as possible.
3. Pass the cable ties through the sensor
holes and loosely adjust the ties. Do not
tighten fully yet. If the cable ties are too
short for your bicycle, put two of them
together to make them longer.
60
°
Riding dir
e
ction
max 50 cm /
1´8´´
1
2
If you are using Polar S725 with Polar
Power Output Sensor, please see the bike
mount and sensor installation instructions
in the Power Output Sensor user manual.
If you use the Power Sensor, you do not
need to mount any other sensors on your
bicycle.